C# Класс WixSharp.DriverInstaller

Specifies that the DIFxApp CustomActions should add an entry in the Add/Remove Programs Control Panel applet. The default is 'true'.

The architecture of the driver to be installed. Default value is 'x86'

If set to "true", configures DIFxApp to delete binary files that were copied to the system from the driver store when a driver package was installed. If this attribute is set to "no" or not present, DIFxApp does not remove these files from a system. Note that configuring DIFxApp to delete these files is controlled by the Flags entry value of the component that represents the driver package in the MsiDriverPackages custom table. Setting DeleteFiles to "true" sets the corresponding bit in the Flags entry value. Setting DeleteFiles to "false" clears the corresponding bit in the Flags entry value. If this attribute is not present, DIFxApp uses a default value of "false".

If set to "true", configures DIFxApp to install unsigned driver packages and driver packages with missing files. For more information, see "Installing Unsigned Driver Packages in Legacy Mode" earlier in this paper. If this attribute is set to "false" or not present, DIFxApp will install only signed driver packages. Note that configuring DIFxApp to install unsigned drivers is controlled by the Flags entry value of the component that represents the driver package in the MsiDriverPackages custom table. Setting Legacy to "true" sets the corresponding bit in the Flags entry value. Setting Legacy to "false" clears the bit in the Flags entry value that configures DIFxApp to install unsigned driver packages. If this attribute is not present, DIFxApp uses a default value of "false".

If set to "true", configures DIFxApp to install unsigned driver packages and driver packages with missing files. For more information, see "Installing Unsigned Driver Packages in Legacy Mode" earlier in this paper. If this attribute is set to "false" or not present, DIFxApp will install only signed driver packages. Note that configuring DIFxApp to install unsigned drivers is controlled by the Flags entry value of the component that represents the driver package in the MsiDriverPackages custom table. Setting Legacy to "true" sets the corresponding bit in the Flags entry value. Setting Legacy to "false" clears the bit in the Flags entry value that configures DIFxApp to install unsigned driver packages. If this attribute is not present, DIFxApp uses a default value of "false"

Specifies that the DIFxApp CustomActions should prompt the user to connect the Plug and Play device if it is not connected. The default is 'true'.

Specifies an optional installation sequence number. DIFxApp CustomActions install the driver packages in an installation package in the order of increasing sequence numbers. The same sequence number can be used for more than one driver; however, the order in which packages with the same sequence number are actually installed cannot be determined.