C# 클래스 GSF.PhasorProtocols.IEEE1344.CommandFrame

상속: CommandFrameBase

파일 보기 프로젝트 열기: GridProtectionAlliance/gsf 1 사용 예제들

Private Properties

프로퍼티	타입	설명

공개 메소드들

메소드	설명
CommandFrame ( byte buffer, int startIndex, int length ) : System	Creates a new CommandFrame from the given buffer. This constructor is used by a consumer to parse a received IEEE 1344 command frame. Typically command frames are sent to a device. This constructor would used if this code was being used inside of a phasor measurement device.
CommandFrame ( ulong idCode, DeviceCommand command ) : System	Creates a new CommandFrame from specified parameters. This constructor is used by a consumer to generate an IEEE 1344 command frame.
GetObjectData ( SerializationInfo info, StreamingContext context ) : void	Populates a SerializationInfo with the data needed to serialize the target object.

보호된 메소드들

메소드	설명
CalculateChecksum ( byte buffer, int offset, int length ) : ushort	Calculates checksum of given buffer.
CommandFrame ( SerializationInfo info, StreamingContext context ) : System	Creates a new CommandFrame from serialization parameters.
ParseHeaderImage ( byte buffer, int startIndex, int length ) : int	Parses the binary header image.

메소드 상세

CalculateChecksum() 보호된 메소드

Calculates checksum of given buffer.

protected CalculateChecksum ( byte buffer, int offset, int length ) : ushort
buffer	byte	Buffer image over which to calculate checksum.
offset	int	Start index into to calculate checksum.
length	int	Length of data within to calculate checksum.
리턴	ushort

CommandFrame() 보호된 메소드

Creates a new CommandFrame from serialization parameters.

protected CommandFrame ( SerializationInfo info, StreamingContext context ) : System
info	System.Runtime.Serialization.SerializationInfo	The with populated with data.
context	System.Runtime.Serialization.StreamingContext	The source for this deserialization.
리턴	System

CommandFrame() 공개 메소드

Creates a new CommandFrame from the given buffer.

This constructor is used by a consumer to parse a received IEEE 1344 command frame. Typically command frames are sent to a device. This constructor would used if this code was being used inside of a phasor measurement device.

must be at least 16.

public CommandFrame ( byte buffer, int startIndex, int length ) : System
buffer	byte	Binary image to parse.
startIndex	int	Start index into to begin parsing.
length	int	Length of valid data within .
리턴	System

CommandFrame() 공개 메소드

Creates a new CommandFrame from specified parameters.

This constructor is used by a consumer to generate an IEEE 1344 command frame.

public CommandFrame ( ulong idCode, DeviceCommand command ) : System
idCode	ulong	The ID code of this .
command	DeviceCommand	The for this .
리턴	System

GetObjectData() 공개 메소드

Populates a SerializationInfo with the data needed to serialize the target object.

public GetObjectData ( SerializationInfo info, StreamingContext context ) : void
info	System.Runtime.Serialization.SerializationInfo	The to populate with data.
context	System.Runtime.Serialization.StreamingContext	The destination for this serialization.
리턴	void

ParseHeaderImage() 보호된 메소드

Parses the binary header image.

protected ParseHeaderImage ( byte buffer, int startIndex, int length ) : int
buffer	byte	Binary image to parse.
startIndex	int	Start index into to begin parsing.
length	int	Length of valid data within .
리턴	int